Postby Mr. OM-NOM » Mon Apr 16, 2012 9:55 am
Yes, there may be a pin in the side of the cylinder at the cylinder head holding the head in place. If there is, youll need to CAREFULLY drill it out, but only the pin, dont put a hole clean through the head. It shouldnt be more than an 1/8th and inch deep. Also, wrap the nozzle in electrical tape then use pliers to twist off the head. Electrical tape will reduce scratching. Or you could put the two tips of the pliers into the two holes on the side and try it that way. After that everythings pretty simple. Just make sure the spring is actuallyon the spring guidewhen you put it back together, and not just to the side.